Livemix auto saves settings and mixes to a temparary location every 2 minutes. If you make an adjustment and power down without saving before it has a chance to auto save, you will lose your changes. It is recommended to…
Livemix works with either analog or digital (Dante) input. With the AD-24 analog input unit you can connect TRS or DB25 connectors from your console or recording interface. For a Digital connection with Dante, plug directly into a switch. For…
Each MIX-16/MIX-32 Control Surface port supports a maximum combined CAT5e (shielded recommended) cable distance of 100 meters.
You can connect two CS-SOLO units to a single port on the MIX-16 or MIX-32. The first mixer is the blue “A MIX” while the second unit will be the red “B MIX”. Power and audio is supplied to the…
The maximum supported CAT5e (shielded required) cable distance of 100 meters.
The maximum supported CAT5e (shielded required) cable distance of 100 meters.
Shielded cable is required for connecting both the AD-24 and the DA-816 to the MIX-16 or MIX-32. Shielded cable is not required for connecting a CS-SOLO or CS-DUO to the MIX-16/32 or connecting the LM-DANTE card to the Dante network.…
We recommend to make the Master clock the console or Dante card in the console. NOTE: There are two ways this can be done. 1) Set the console's internal clock as Master, then using Dante Controller, set the console's Dante…
You will need to select Sync to External if the word clock on our console is not set to slave or if you are using any other clock source. i.e Madi, AES50 etc.
48kHz has long been the standard for network audio, offering the combination of the most compatibility, fidelity and throughput.