Make a great personal mix with the Livemix CS-SOLO, the most feature rich personal mixer on the market. The LCD touchscreen with custom naming makes creating a mix easy. Dedicated knobs provide quick access to essential features. The CS-SOLO provides 24 channels plus accessory channels, each with EQ and compression. The master output features EQ, compression and reverb.
MirrorMix® remote setup and mixing, mute and solo options, channel grouping and LCD dimming make the Livemix system deep enough for professionals, but simple enough for volunteers. To maximize stage mixes, connect two CS-SOLO units to a single port on the MIX-16 or MIX-32. The first personal mix is the blue “A Mix” while the second personal mixer unit will be the red “B Mix”. Power and audio is supplied to the second CS-SOLO over a network cable connected to the CS-SOLO THRU port.
|Output Power & THD+N||@22Ω||200mW @ 1% THD+N|
|100mW @ .03% THD +N|
|@32Ω||250mW @ 1% THD+N|
|100mW @ .014% THD +N|
|@64Ω||250mW @ 1% THD+N|
|100mW @ .005% THD +N|
|@300Ω||130mW @ 1% THD+N|
|100mW @ .003% THD +N|
|Frequency Response||20 Hz – 22 kHz ± 3 dB|
|S/N Ratio||103 dB|
|Input Impedance (Aux In)||7.5 kΩ|
|Crosstalk (Left to Right)||-103 dB|
|Max Cable length from MIX-16||100m CAT5e cable
|Filter Q||High Pass & Low Pass||.707|
|Filter Cut/Boot Amount||± 6 dB|
|Ambient Mic Gain||25 dB|
We recommend to make the Master clock the console or Dante card in the console. NOTE: There are two ways this can be done. 1) Set the console’s internal clock as Master, then using Dante Controller, set the console’s Dante card as Master clock (for the Dante Network) and also check box “Sync to External”. This will allow the card to stay synched to the console’s master clock. 2) Set the console’s internal clock to be slave of the console’s Dante card. Using Dante controller, set the console’s Dante card as Master clock.